National Instruments PC-DIO-24/PnP, Руководство пользователя

Страница: 78 / 107

Appendix C Register-Level Programming
PC-DIO-24/PnP User Manual C-18
©
National Instruments Corporation
During a mode 2 data transfer, the status of the handshaking lines and
interrupt signals can be obtained by reading port C. The port C status-
word bit definitions for a mode 2 transfer are shown as follows.
Port C status-word bit definitions for bidirectional data path (port A
only):
Bit Name Description
7 OBFA* Output Buffer for Port A—A low setting indicates that
the CPU has written data to port A.
6 INTE1 Interrupt Enable Bit for Port A Output Interrupts—
Setting this bit enables output interrupts from port A
of the 82C55A. This bit is controlled by
setting/resetting PC6.
5 IBFA Input Buffer for Port A—A high setting indicates that
data has been loaded into the input latch of port A.
4 INTE2 Interrupt Enable Bit for Port A Input Interrupts—
Setting this bit enables input interrupts from port A of
the 82C55A. This bit is controlled by setting/resetting
PC4.
3 INTRA Interrupt Request Status for Port A—If INTE1 and
IBFA are high, then this bit is high, indicating that an
interrupt request is pending for port A input transfers.
If INTE2 and OBFA* are high, then this bit is high,
indicating that an interrupt request is pending for
port A output transfers.
2–0 I/O Input/Output—These bits can be used for general-
purpose I/O lines if group B is configured for mode 0.
If group B is configured for mode 1, refer to the bit
explanations shown in the preceding mode 1 sections.
D7 D6 D5 D4 D3 D2 D1 D0
OBFA* INTE1 IBFA INTE2 INTRA I/O I/O I/O