National Instruments NI VISION PCI-8254R, Начало работы

Страница: 5 / 13

Getting Started with the NI PCI-8254R 4 ni.com
wiring, including cables, bus-bars, junction boxes, switches, socket-outlets in the fixed installation,
and stationary motors with permanent connections to fixed installations.
• Measurement Category IV is for measurements performed at the primary electrical supply
installation (<1,000 V). Examples include electricity meters and measurements on primary
overcurrent protection devices and on ripple control units.
Unpacking
The NI 8254R ships in an antistatic package to prevent electrostatic discharge from damaging device
components. To avoid such damage in handling the device, take the following precautions:
1. Ground yourself using a grounding strap or by holding a grounded object, such as the computer
chassis.
2. Touch the antistatic package to a metal part of the computer chassis before removing the device
from the package.
Caution
Never touch the exposed pins of connectors.
3. Remove the device from the package and inspect it for loose components or any other signs of
damage. Notify National Instruments if the device appears damaged in any way. Do
not install
a damaged device in the computer.
Store the NI 8254R in the antistatic package when not in use.
Installation
The following instructions are for general installation. Refer to the documentation provided by your
computer manufacturer for specific instructions and warnings. Refer to the
Specifications section for
typical power requirements for the NI 8254R.
1. Install NI Vision Acquisition Software before installing the NI 8254R. Refer to the
NI Vision Acquisition Software Release Notes for specific installation instructions.
2. Power off and unplug the computer.
Caution To protect yourself and the computer from electrical hazards, the computer
must
remain
unplugged until the installation is complete.
3. Remove the computer cover to expose the expansion slots.
4. Touch a metal part on the computer case to discharge any static electricity on your clothes or body.
Static electricity can damage the device.
5. Choose an unused PCI slot, and remove the corresponding expansion slot cover on the back panel
of the computer.
6. Remove your device from the antistatic package and gently rock the device into the slot. The
connection may be tight, but do
not force the device into place.
Note Check that the bracket of your device lines up with the hole in the back panel rail of the
computer chassis.
7. Secure the device mounting bracket to the back panel rail of the computer.