Getting Started with NI SMD-7620/7621 and NI 9512 Modules
|
© National Instruments
|
5
b.
Align the controller with the chassis as shown in Figure 2.
Figure 2.
Installing the Controller on the Chassis (Eight-Slot Chassis Shown)
c.
Slide the controller onto the controller slot on the chassis. Press firmly to ensure the
chassis connector and the controller connector are mated.
d.
Using a number 2 Phillips screwdriver, tighten the two captive screws on the front of
the controller.
2.
Connect the controller to a power supply and an Ethernet network on the same subnet as
the development computer. Refer to the controller operating instructions for information
about wiring the controller to the power supply and Ethernet network.
Note
Do not plug in or turn on any power to the system until after you complete
Step 11: Power on the Drive and Verify Connections
3.
Install the NI 9512 module in slot 1, 2, 3, or 4 of the chassis.
1
Controller
2
Captive Screws
3
Controller Slot
4
Reconfigura
b
le Em
b
edded Chassis
5
Grounding Screw
1
4
2
3
5