National Instruments NI SCXI-1336, Руководство пользователя

Страница: 32 / 83

Chapter 1 Installing and Configuring the SCXI-1129
© National Instruments Corporation 1-23 SCXI-1129 User Manual
4. To configure the chassis, select the Chassis ID . The chassis ID is an
arbitrary number that you choose for use by the software to uniquely
specify the chassis.
5. Select the Chassis Address (refer to your SCXI chassis user manual
for further information).
For the SCXI-2000, you also need to select the Baud Rate and
COM Port .
You now have the choice of auto-detecting your modules or manually
adding them depending on your application.
Auto-Detecting Modules
If you selected auto-detect and the chassis is not an SCXI-2000 remote
chassis, you must have your chassis connected to your National
Instruments device.
Note Make sure you have your chassis powered on.
1. Click Next .
2. Select your communication path, except in the case of the SCXI-2000,
and click
Next .
3. Select the module cabled to your communication path, except in the
case of the SCXI-2000 or if your module supports Auto Cable Detect,
and click
Finish .
Note The SCXI-1129 has Auto Cable Detect, which means that just by connecting the
communications cable to the SCXI-1129, the software can identify that the SCXI-1129 is
the cabled module.
Your SCXI chassis and SCXI-1129 modules are now configured in the
software with your modules. To configure the properties for a particular
module, perform the following steps:
1. Expand Devices and Interfaces . You see the chassis selected in the
list.
2. Expand Chassis .
3. Right-click the module you want to configure and select Properties .
Tabs are displayed containing attributes for different properties of the
module. You can select any tab to see and/or change any attributes.