2-2
|
ni.com
Chapter 2
Installation and Configuration
Figure 2-1.
Removing Protective Screw Caps
3.
Make sure the injector/ejector handle is in its downward position. Align the PXIe-8840
with the card guides on the top and bottom of the system controller slot.
Caution
Do
not
raise the injector/ejector handle as you insert the PXIe-8840. The
module will not insert properly unless the handle is in its downward position so that
it does not interfere with the injector rail on the chassis.
4.
Hold the handle as you slowly slide the module into the chassis until the handle catches on
the injector/ejector rail.
5.
Raise the injector/ejector handle until the module firmly seats into the backplane receptacle
connectors. The front panel of the PXIe-8840 should be even with the front panel of the
chassis.
6.
Tighten the four bracket-retaining screws on the top and bottom of the front panel to secure
the PXIe-8840 to the chassis.
7.
Check the installation.
8.
Connect the keyboard and mouse to the appropriate connectors. If you are using a PS/2
keyboard and a PS/2 mouse, a Y-splitter adapter is available to connect both to a single USB
connector. Refer to Figure 4-1,
Y-Splitter Cable
.
1
Protective Screw Cap (4x)
1
Содержание NI PXIe-8840
Страница 1: ...PXI Express PXIe 8840 User Manual PXIe 8840 User Manual April 2018 374236B 01...
Страница 8: ...PXIe 8840 User Manual National Instruments ix Appendix A Specifications Appendix B NI Services...
Страница 59: ...National Instruments 5 3 PXIe 8840 User Manual Figure 5 1 Clearing the CMOS Contents 1 Push Button Switch S1 1...
