©
National Instruments Corporation
25
MID-7654/7652 Servo Power Motor Drive User Guide
Panel Mount Kit Installation
The panel mount kit allows you to mount the MID-7654/7652 inside a cabinet or enclosure. Attach the
panel mount kit to the rear and front set of screw holes on the side panels of the MID-7654/7652,
as shown in Figure 24, using the provided screws.
Figure 24.
MID-7654/7652 with the Panel Mount Kit Installed
Note
The strain-relief bar and panel mount kit cannot be installed at the same time, because they
will not simultaneously fit under the sides of the bottom mounting plate.
Modifying the Power Entry Module
This section covers replacing fuses and switching the line voltage for your drive.
Replacing a Fuse
Follow these steps to replace a fuse on your MID-7654/7652:
1.
Pry open the hinged cover on the power entry module (number 7 in Figure 6).
2.
Remove the fuse holder. Notice how the fuse holder is oriented so you can replace it properly.
3.
Replace the blown fuse in the fuse holder. Be sure the new fuse is oriented in the same way as the
original fuse, and that it is rated at the proper voltage.
4.
Push the fuse holder back into the power entry module with the same orientation you observed in
step 2.
5.
Close the hinged cover.
1
Rear Guard Assembly
2
Panel Mount
NA
TIO
NA
L
INS
TRU
ME
NT
S
1
2