NI HDD-8265 Battery Pack Accessory Installation Guide
2
ni.com
2.
Remove the bracket blank from the chassis by unscrewing the
retention fastener and sliding the bracket out in the direction shown in
Figure 3. You may need a 6 mm wrench or small adjustable crescent
wrench (not included in the kit) to loosen the fastener.
Figure 3.
Removing the Bracket Blank
3.
Insert one end of the ribbon cable included with the battery pack
accessory kit into the 12-pin connector labeled
J1
on the battery pack
card, as shown in Figure 4.
Figure 4.
Inserting the Ribbon Cable into the Battery Pack Accessory
1
Bracket Blank
2
Retention Fastener
1
2