NI DCM-2316 Getting Started Guide
|
© National Instruments
|
3
•
DCM Starter Harness kit
•
Piezo or Solenoid Injector
•
12 V or 24 V DC power supply, 180 W
1
minimum DC power supply
Software Installation
The DCM may be used with several different software personalities. Each personality requires
different software packages to be installed on the host computer which may need to be
individually licensed.
NI Powertrain Controls supports the following software personalities for the DCM:
•
DCM Default Software Image (DSI)
•
NI LabVIEW
•
NI VeriStand
DCM Default Software Image (DSI)
Before using the DCM DSI, you must install the following application software and device
drivers on the host computer in this order:
•
NI CompactRIO Device Drivers 16.0 or later
Software Calibration Management (SCM) Toolkit 2016 or later (evaluation license)
Note
The DCM is shipped supporting the latest version of SCM. If you have
trouble launching the DCM DSI with the latest available version of SCM on
,
the software on your DCM may need to be updated. Refer to the
NI DCM-23XX DSI
User Guide
for more information.
For minimum software support information, visit
and enter the Info Code
swsupport
.
DCM With LabVIEW
Before using the DCM with LabVIEW, you must install the following application software and
device drivers on the host computer in this order:
•
LabVIEW 2016 or later
•
LabVIEW Real-Time Module 2016 or later
•
LabVIEW FPGA Module 2016 or later
•
NI CompactRIO Device Drivers 16.0 or later
•
NI Powertrain Controls Device Drivers 2.160.0.0 or later
1
Minimum power supply requirements assume basic operation; actual power supply
requirements will vary depending on hardware and software configuration.