©
National Instruments Corporation
9
NI Switches Getting Started Guide
Install and configure the controller as described in its documentation. Refer
to the
DAQ Quick Start Guide
for installing an E Series or NI 4021 device
and the
NI Digital Multimeters Getting Started Guide
for installing the
NI 4060/4070.
Installation
After you have installed and configured the controller, refer to the
flowchart in Figure 3 for your next steps.
50-pin
SCXI-1160
SCXI-1362 kit
SCXI-1362 kit
SCXI-1362 kit
SH6868-EP and
SCXI-1349
SCXI-1161
SCXI-1163R
SCXI-1190
SCXI-1191
SCXI-1192
1
The NI 4060 cannot control the SCXI-1130/1166/1167 or SCXI-1193 switch modules. For software support information,
refer to Table 3.
2
An E Series device can control these switches when cabled to another SCXI module in the same chassis. The cabled SCXI
module can be an SCXI signal conditioning device or other SCXI switch module. Alternatively, you can install the E Series
device in the rightmost PXI slot of a PXI-1010 or PXI-1011 chassis.
Table 2.
SCXI Controllers and Supported SCXI Switches (Continued)
Rear
Connector
Switch Module
SCXI Switch Controllers
NI 4021
NI 4060
NI 4070
E Series
