Getting Started with NI SMD-7620/7621 and NI 73xx
|
© National Instruments
|
15
Figure 11.
UMI-7772/7774 V and V
iso
LED Location
If the
V
and
Viso
LEDs do not illuminate, turn off all power, verify the connections, and
try again.
Note
Software Installation and Configuration
section to continue
setting up your system.
Connecting and Using the NI SMD-7620/7621
with the NI UMI-7764
What You Need to Get Started
You need the following items to get started.
Hardware
A computer with an available PXI or PCI slot
NI 7330, NI 7340, or NI 7350 motion controller
UMI-7764
SH68-C68-S cable to connect your NI UMI and motion controller
+5 V power supply for the UMI-7764
Snap-on ferrite bead for the power supply cable (included with your NI UMI-7764). Refer
to the
UMI-7764 User Guide and Specifications
for installation information.
NI SMD-7620/7621 stepper drive
NI or third-party stepper motor
FAULT
FWD
HOME
REV
FAULT
FWD
HOME
REV
FAULT
FWD
HOME
REV
FAULT
FWD
HOME
REV
LIMIT LED
FAULT
ENABLE
LIMIT LED
FAULT
ENABLE
LIMIT LED
FAULT
ENABLE
LIMIT LED
FAULT
ENABLE