©
National Instruments Corporation
13
NI High-Speed Digitizers Getting Started Guide
3. Enter the correct string into the
resource name
control or parameter.
This string varies depending on whether the digitizer is a Traditional
NI-DAQ device or an NI-DAQmx device. For more information about
device names, refer to any of the following resources.
•
Section
6. Configuring and Testing in MAX
•
NI-SCOPE VI Reference Help»niScope Initialize
•
NI-SCOPE C Function Reference Help»niScope_init
4. Adjust the parameters, if necessary, to capture the input signal that you
want to acquire.
5. Connect the signal that you want to acquire to one of the input channels
of the digitizer. For information about the appropriate connections, refer
to
Appendix A: Front Panels for SMC-Based Devices
Front Panels for Traditional NI-DAQ (Legacy) Devices
.
6. Run the example program.
Appendix A: Front Panels for SMC-Based
Devices
This appendix describes digitizer front panels and signal connections for
SMC-based devices: NI 5105, NI 5114, NI 5122, NI 5124, NI 5142,
NI 5152, and NI 5922.