©
National Instruments Corporation
2-1
MXI-Express (x1) for PXI Express Series User Manual
2
Hardware Installation
This chapter explains how to install the MXI-Express hardware.
Hardware Installation
The following are general instructions for installing the MXI-Express
cards. Consult your computer user manual or technical reference manual
for specific instructions and warnings.
Note
The PXI Platform Services software on the
PXI Platform Services
CD or driver CD
included with your PXI Express MXI-Express hardware is required to provide chassis and
controller identification for PXI features such as trigger routing and slot detection. The PXI
Platform Services software is also included with the NI-DAQmx and NI-VISA drivers. For
more information, refer to KnowledgeBase 3TJDONDS at
ni.com
.
Installing an NI PCIe-8361/8362
1.
Power off your computer, but leave it plugged in while installing the
NI PCIe-8361/8362. The power cord grounds the computer and
protects it from electrical damage while you install the card.
Caution
To protect both yourself and the computer from electrical hazards, your computer
should remain off until you finish installing the NI PCIe-8361/8362.
2.
Remove the top cover or access port to the PCI Express bus.
3.
Select any available PCI Express expansion slot (x1 or wider).
Note
The BIOS or motherboard may not support the NI PCIe-8361/8362 in a slot intended
for a graphics card.
4.
Locate the metal bracket that covers the cut-out in the back panel of the
computer for the slot you have selected. Remove and save the
bracket-retaining screw and the bracket cover.
5.
Touch the metal part of the power supply case inside the computer to
discharge any static electricity that might be on your clothes or body.
