Chapter 1
Introduction to the LabVIEW Order Analysis Toolset
©
National Instruments Corporation
1-5
LabVIEW Order Analysis Toolset User Manual
set to
DAQ
and you click the
Run
button on the front panel of the
example VI, one of the following VIs opens:
•
Acquire Data (Analog Tach) VI
•
Acquire Data with PXI 4472 and TIO VI
Refer to the
the Acquire Data (Analog Tach) VI and the
section for information about the Acquire Data with PXI 4472
and TIO VI.
Acquire Data (Analog Tach) VI
In analog tachometer examples, setting
Data Source
to
DAQ
and clicking
the
Run
button opens the Acquire Data (Analog Tach) VI. The Acquire
Data (Analog Tach) VI helps you acquire vibration data with a digital
tachometer signal. Figure 1-1 shows the
Configuration
tab of the Acquire
Data (Analog Tach) VI.
Figure 1-1.
Acquire Data (Analog Tach) VI Configuration Tab
You must configure two channels of the DAQ device before you acquire
data. Use the
Configuration
tab of the Acquire Data (Analog Tach) VI,
shown in Figure 1-1, to configure your DAQ device. In the
Channel
Settings
section of the
Configuration
tab, use
Tachometer
for the
