Chapter 1
Introduction to the LabVIEW Order Analysis Toolset
LabVIEW Order Analysis Toolset User Manual
1-6
ni.com
tachometer signal and
S&V
for the sound or vibration sensor. After
choosing data acquisition settings, enter the number of pulses you want the
tachometer to generate per revolution in the
Tach
Pulse/Rev
text box.
Use the controls in the
Channel Info
section of the
Configuration
tab to
specify the channel information for the sound or vibration sensor.
After configuring the DAQ device, click the
Acquisition
tab, shown in
Figure 1-2.
Figure 1-2.
Acquire Data (Analog Tach) VI Acquisition Tab
The
Acquisition
tab, shown in Figure 1-2, allows you to acquire and
observe data. Click the
Acquire
button to acquire data. Continue to
configure the data acquisition and acquire data until you acquire the data
you want. Click the
OK
button to return to the front panel of the example
VI to analyze the data.
Acquire Data with PXI 4472 and TIO VI
In digital tachometer examples, setting
Data Source
to
DAQ
and clicking
the
Run
button opens the Acquire Data with PXI 4472 and TIO VI. The
Acquire Data with PXI 4472 and TIO VI helps you acquire vibration data
with a digital tachometer signal. Figure 1-3 shows the
Configuration
tab
of the Acquire Data with PXI 4472 and TIO VI.
