©
National Instruments Corporation
4-1
4
Signal Connections
This chapter describes cable connections for the PCI-1409 and PXI-1409
devices.
BNC Connector
The BNC external connector supplies an immediate connection to the
1409 device VIDEO0 input. Use the 2 m BNC cable shipped with the
PCI/PXI-1409 to connect a camera to VIDEO0. You cannot use this
connection with VIDEO0 on the 68-pin VHDCI I/O connector. You
can configure the BNC connector only for RSE mode.
Note
Verify that Jumper W1 is installed when using the BNC input.
Figure 4-1.
BNC Connector Pin Assignment
I/O Connector
The 68-pin VHDCI connector connects to all video signals (VIDEO0,
VIDEO1, VIDEO2, and VIDEO3), the external digital I/O lines, triggers,
and external signals. To access these connections, you can build your own
custom cable or use one of the optional cables from National Instruments.
Figure 4-2 shows the pinout of the 68-pin VHDCI connector.
Note
Do
not
use the VIDEO0 connection on the 68-pin VHDCI connector when using the
BNC connection.
GND