Figure 7. Isolated Power Input Connector (IP67)
4
3
1
2
1. C (Negative) Terminal
2. V (Positive) Terminal
3. No connect
4. No connect
Complete the following steps to supply power to the isolated outputs.
1.
Verify the power source is turned off. Verify the power source for ISO PWR IN is
between 4.5 V to 30 V.
2.
If you are not using a pre-assembled cable, complete the following steps.
a)
Connect the positive lead of the primary power source to the V1 terminal inside the
power connector plug.
b)
Connect the negative lead of the primary power source to the C terminal inside the
power connector plug.
c)
Assemble the rest of the plug sleeve. Go to
and enter Info Code
317xIP67Connector for instructions.
3.
Install the isolated power connector into ISO PWR IN on the front panel of the controller.
4.
Turn on the external power source(s).
Note
Refer to the
IC-317x User Manual
for a complete
description of power inputs and controller startup options.
Connecting the DisplayPort Connector
Install one ferrite, NI part number 711856-01, on each DisplayPort cable, approximately 50
mm to 75 mm (2 in. to 3 in.) from the end of the power input wires.
Figure 8. Installing a Ferrite on the Cable
12
|
ni.com
|
IC-317x Getting Started Guide
