Chapter 2
Configuration and Startup Procedures
2-14
ni.com
System Startup Message Printing
The serial port startup printout enable switch S21 controls whether or not
VXI system startup messages are printed to the serial port, as shown in
Figure 2-9. The factory default configuration disables this function.
Figure 2-9.
VXI System Startup Message Switch Settings
Slot 0 Resource Manager Configuration
You can configure the GPIB-VXI/C for Slot 0 Resource Manager operation
by enabling the VXIbus Slot 0 functions and setting the logical address
to 0, as shown in Table 2-7.
Table 2-7.
Slot 0 Resource Manager Operation Switch and Jumper Settings
Jumper/Switch
Position
Function
Switches S9 and S15
Refer to Table 2-8.
CLK10 routing options.
Switch S22
ON
VXI BTO enabled.
Switch S23
ON
Bus arbiter and SYSCLK enabled.
CLK10 sourcing for backplane is
enabled.
Switch S24
ON
MODID pulled up.
Logical Address
Refer to Chapter 4,
Logical address is 0. Set in nonvolatile
configuration or use the DIP switch.
Slot 0 Model Code
Refer to Chapter 4,
Model code is set to the Slot 0 value.
Set in nonvolatile configuration.
a. Printing Disabled
(Factory Configuration)
b. Printing Enabled
S21
S21
