Chapter 4
NI-FBUS CM Software
©
National Instruments Corporation
4-11
NI-FBUS Hardware and Software User Manual
HSE Device MIB List Parameters
SCHEDULE_DESCRIPTOR
VFD_REF_ENTRY
CONFIGURED_SESSION_ENTRY
AUTOMATIC_SESSION_ENTRY
HSE_CONFIGURED_VCR_ENTRY
HSE_AUTOMATIC_VCR_ENTRY
HSE Device MIB Parameters
SM_SUPPORT
OPERATIONAL_POWERUP
LIST_OF_VERSION_NUMBERS
OPERATIONAL_IP_ADDRESS
LOCAL_IP_ADDRESS_ARRAY
SYNC_AND_SCHEDULING
LAST_SNTP_MESSAGE
SNTP_TIMESTAMPS
DEVICE_IDENTIFICATION
SCHEDULE_ACTIVATION_VARIABLE
SCHEDULE_LIST_CHARACTERISTICS
NM_CHARACTERISTICS
CONFIGURED_SESSION_LIST_HEADER
AUTOMATIC_SESSION_LIST_HEADER
HSE_CONFIGURED_VCR_LIST_HEADER
HSE_AUTOMATIC_VCR_LIST_HEADER
BRIDGE_CHARACTERISTICS
CURRENT_NMA_CONFIGURATION_ACCESS
PREVIOUS_NMA_CONFIGURATION_ACCESS
INTERFACE_ADDRESS_ARRAY
INTERFACE_DESIRED_STATE_ARRAY
INTERFACE_ACTUAL_STATE_ARRAY
Use the NI-FBUS Dialog Utility to Communicate with Devices
The NI-FBUS Dialog utility helps you perform simple tests of your whole
Fieldbus setup, including the NI-FBUS Communications Manager, your
interface board(s), and any devices you have. The NI-FBUS Dialog utility
has dialog boxes that call the NI-FBUS Communications Manager API,
allowing you to specify parameters and make NI-FBUS calls. For example,
you can use the NI-FBUS Dialog utility to get a list of devices on your
network, as well as view and set parameters in each device. For more
information on using the NI-FBUS Dialog utility, refer to the
section.