Chapter 10
Installation and Operation
©
National Instruments Corporation
10-7
On the SC-2056, J1 connector has the same pin assignment as the DAQ
device. Connectors J2 and J3 are used with the R1005050 cable to connect
the SC-2056 to the DAQ device. On the SC-2057 the pin assignments on J1
and J2 have the same pin assignment as the AT-DIO-32F without the
handshaking lines. Connectors P1 and P2 are connected pin-by-pin and
have exactly the same pin assignment as the DAQ device. Use one
connector to connect the SC-2057 to the VXI-DIO-128. You can connect
the remaining connector via a cable to a terminal block or other accessories.
The 26-pin connectors J3, J4, J5, and J6 on the SC-2052 and SC-2053,
connect to SC-206X Series adapters or 5B Series signal conditioning
boards with type NB7 cable, or to 8-channel SSR Series backplane with
26-conductor cabling. The 26-pin connectors J4, J5, J6, J8, J9, and J10 on
the SC-2054 are for connection to SC-206X Series adapters. The 26-pin
connectors J8, J9, J10, J11, J12, and J13 on the SC-2056 are for connection
to SC-206X Series, SSR Series, and 5B Series boards. You must make these
connections with the host computer powered off.
Warning
Do not attempt to connect any SC-205X adapter to any board for which it was not
designed. Such connection can result in damage to the SC-205X adapter and any
or all boards connected to the SC-205X adapter and the host computer. National
Instruments is
NOT
liable for any damages resulting from incorrect connections.
For additional information concerning the connection of these signals on
the accessory boards, consult the SC-206X Series User Manual, the
5B Series User Manual, the SC-207X Series User Manual, the AMUX-64T
User Manual, or the user manuals for your SSR Series backplane and
CB-50 terminal block.
