National Instruments cRIO-FRC, Руководство пользователя, Страница: 2 / 14

Preparation
Before getting started, make sure you have the following tools and an appropriate work environment.
Required Tools:
•
#1 Philips Head Screwdriver (
Caution
: If you use a different-sized screwdriver, you can easily
destroy the cross recesses in the screw heads, making the screws nearly impossible to tighten or
remove. Do not use a power screwdriver.)
On the left is a #1 screwdriver. On the right is a different-sized screwdriver.
•
Compressed air
•
Protective Gasket Kit
•
Small, soft, clean paintbrush with non-conductive bristles
•
Small Ziploc® bag or other sealable container for holding loose parts such as screws
•
ESD grounding wrist straps and an ESD mat, properly installed and grounded
NOTE: You should use an ESD mat whenever you handle electronics. However, if a mat is not
available, you can discharge static electricity from your body by touching the bare metal of a
grounded computer or other electrical equipment before touching the cRIO-FRC.