____________________________
Product and company names are trademarks or trade names of their respective companies.
320104-01
© Copyright 1993, 1994 National Instruments Corporation. All rights reserved.
October 1993
NATIONAL
INSTRUMENTS
®
The Software is the Instrument
®
Installation Guide
CB-50 Connector Block
This guide describes how to connect your data acquisition board and the CB-50 I/O connector
block to your computer.
Introduction
With the CB-50 I/O connector block, you can easily connect analog/digital signals to the
National Instruments data acquisition boards. You can use the CB-50 with the following boards:
PC/XT, PC AT
PS/2
Macintosh
AT-MIO-16
MC-MIO-16
NB-MIO-16
AT-MIO-16F-5
MC-DIO-32F
NB-MIO-16X
AT-MIO-16X
MC-DIO-24
NB-DIO-32F
AT-AO-6
NB-DIO-24
AT-AO-10
NB-AO-6
AT-DIO-32F
NB-TIO-10
AT-DIO-24
Lab-NB
Lab-PC
Lab-SE
Lab-PC+
PC-LPM-16
PC-DIO-24
PC-TIO-10
The CB-50 consists of a 0.5 m or 1.0 m ribbon cable and a connector block with 50 screw
terminals. Connector pinout information is in the user manual for each data acquisition board.
At each end, the cable has a keyed connector with a centered tab that you must align with the slot
on the mating header on the connector block or board.
