NI CB-37F-LP Installation Guide
2
ni.com
What You Need to Get Started
You need the following to set up and use your connector block:
❑
NI CB-37F-LP Connector Block Assembly
❑
Installation Guide
❑
One of the following:
–
NI 6010 device
–
NI 6510/6516/6517/6518/6519 device
❑
NI 6010 Help
or
Digital I/O Help for NI 6509/651x /6528 Devices
❑
0.10 in. slotted screwdriver
❑
Wire cutters
❑
Wire insulation stripper
❑
Number 1 Phillips screwdriver
❑
SH37F-37M cable (if not mounting directly to the NI device)
Safety Information
Cautions
Do
not
operate the device in an explosive atmosphere or where there may be
flammable gases or fumes.
Do
not
operate damaged equipment. The safety protection features built into this device
can become impaired if the device becomes damaged in any way. If the device is damaged,
turn the device off and do
not
use it until service-trained personnel can check its safety.
If necessary, return the device to National Instruments for service and repair to ensure that
its safety is not compromised.
Do
not
operate this equipment in a manner that contradicts the information specified in this
document. Misuse of this equipment could result in a shock hazard.
Do
not
substitute parts or modify equipment. Because of the danger of introducing
additional hazards, do
not
install unauthorized parts or modify the device. Return the
device to National Instruments for service and repair to ensure that its safety features
are not compromised.
You
must
insulate all signal connections to the highest voltage with which the CB-37F-LP
can come in contact.
