Chapter 5
Configuration Utility
PCI/PXI-1408 and NI-IMAQ for Win95/NT
5-2
©
National Instruments Corporation
Figure 5-1. StillColor Modes Dialog Boxes
The following is a description of each of the tabs in the
IMAQconf
utility.
Description Tab
The Description tab in the
IMAQconf
configuration utility is where
basic information about your IMAQ board is stored, such as the
interface name, board type, base address, and interrupt the board uses.
Figure 5-2 shows the information included in this tab.
IMAQconf
automatically fills in this information.
StillColor
Composite
PAL or NTSC Camera Mode
StillColor RGB
Tri-CCD Camera Mode
(Red, Green, and Blue) Linked
to Channel 1, 2, and 3
StillColor
Disabled
Monochrome Mode
Advanced Camera Settings 2
CLAMP Start/Stop and ZERO
Start/Stop Are Specific to
Composite Mode
Basic Camera Settings
Attributes Are Common to All Three Modes
Advanced Camera Settings 1
CLAMP Start/Stop and ZERO
Start/Stop Are Specific to
Monochrome and RGB Modes
Basic StillColor Settings
All the Attributes Are Specific to Composite
Except Averaging and Image Representation
Advanced StillColor Settings
All the Attributes Are Specific to Composite
Except Hue Offset Angle