22 / 28
• During the Max/Min display, press the MEM button for about 3 seconds to clear the Max/Min data.
Every day at 0:00 a.m. the max/min data record is automatically deleted.
• In normal display mode, press the ALARM button to display the currently set alarm time.
13 Alarm setting
1. Press the ALARM button to display the alarm time.
2. Press the ALARM button for approx. 2 seconds to enter the alarm time settings mode.
3. Digits to be set are flashing.
4. Press UP or DOWN button to change the value.
5. Press the ALARM button to confirm the entry and move to the next setting.
6. Sequence of the settings: Hours > minutes
7. Finally, press the ALARM button to save the settings and exit the setting mode.
8. In normal display mode, press the ALARM button to display the currently set alarm time.
9. While the alarm is displayed, press the ALARM button to enable or disable the alarm.
14 Snooze function
1. When the alarm sounds, press the SNOOZE/LIGHT button to activate the snooze function. The
alarm sounds again after 5 minutes.
2. When the alarm sounds, press any other key to stop the alarm until the set alarm time is reached
again.
3. If no key is pressed, the alarm is automatically switched off after 2 minutes.
15 Clima indicator
1 DRY: dry (humidity <40%)
2 COMFORT: Optimal (humidity between 40%
and 70%)
3 WET: Humid (humidity >70%)
The climate indicator is a visual display based on air temperature and humidity to determine the level
of comfort.
Note:
• The comfort display may vary at the same temperature, depending on the humidity.
• There is no comfort display if the temperature is below 0°C or above 60°C.
16 Weather forecast
The weather forecast is calibrated according to the air pressure and displayed with 5 status symbols:
sunny, partly cloudy, cloudy, rainy and snowy.
