PREPARATION
1.
Ensure that the motorcycle is on flat level ground.
2.
It is recommended that the motorcycle sit for at least one hour prior to
installation to allow the engine to cool.
INSTALLATION OF RIGHT SIDE Highway Bar
NOTE: Removing one screw at a time from the foot brake bracket
as
instructed
will facilitate installation.
3.
Select the right side Highway Bar.
4.
Remove the rearward screw from the foot brake bracket. (14mm Wrench)
5.
Loosely install the Highway Bar to the
rearward
position using a M10 x
30 Screw and Nylon Washer.
Place Washer between Highway Bar and
foot brake bracket. Figure 1.
6.
Swivel Highway Bar forward and rest on a protected surface while you
remove the
forward
screw from the foot brake bracket. (14mm Wrenches)
Figure 2.
7.
Loosely install the Highway Bar using the M10 x 90 Screw (no washer.)
Note:
Foot brake clearance and operation should be carefully checked after
installation is complete.
Install Upper “U” Bolt
8.
From the inside, place the “U” Bolt on the frame down tube near the top
of the radiator.
Loosely
install the upper Highway Bar with Whizlock Nuts
(13mm Wrench.)
Figure 1.
Orient assembly so Whizlock Nuts face outside.
Do not tighten.
Figure 3.
By National Cycle
INSTALLATION AND OWNER’S MANUAL
P4013 Highway Bar
for HONDA® VT 750 AERO
NOTE:
Right and Left side of Motorcycle is determined
while sitting on the bike.
PARTS LIST
Index
Part No.
Description
Qty.
1
90-970112-000
Highway Bar, Left
1
2
90-970113-000
Highway Bar, Right
1
BAG 675
3
51-515995-000
Screw, M10-1.25 x 95, zinc
1
4
51-515930-000
Screw, M10-1.25 x 30
3
5
51-513052-000
“U” Bolt
2
6
42-431010-000
Whizlock Nut, Chrome
4
7
49-490210-001
Washer, Nylon
3
Two, Wrenches 14mm
Wrench 13mm
Wrench 12mm
8mm Hex Key
Torque Wrench with Drive and 8mm Hex Bit
Page1 of 2
Figure 1
Place Washer
Between High
Way Bar and
Foot Brake
Bracket.
Parts List, Right Side
Parts List, Left Side
Figure 2
Right Side Finished Installation
6
5
2
1
Figure 3
