©2011 National Cycle, Inc. PO Box 158, Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e-mail: [email protected]
Page 3 of 4
10-117840-000 08/11
INSTALLATION OF BRACKET and WING DEFLECTORS
1.
Replace the trim strips to the fairing working opposite of the way
they were removed. Starting at the top push the top edge of the
trim strip into the slot and work the outside edges strip into the
notches and gently push in the back edges. Work your way down
to the bottom of the trim strip. Holes in trim should align with
standoffs.
Figure 6.
Figures 7, 8 and 9 are not photographed on the 2012
model, however installation remains the same.
2.
Install Right Bracket with 3/8” Screws.
(1/8” Hex Key) Figure 7
3
. Position Swivel Ratchet so studs face toward rider.
Figure 7
4.
Install Neoprene Washers on studs.
Figure 8
5.
Use a Washer and a 1/4” Screw to attach Upper and Lower
Deflectors to Swivel Ratchet.
(Phillips Screw Driver) Figure 9
6.
Tighten Screws firmly, do not over-tighten.
(Phillips Screw
Driver) 6 in/lb (.7 Nm)
7.
Repeat procedure on Left side of motorcycle.
Figure 8
Figure 6
Figure 7
Figure 9
Installed view includes N5108 Mirror Deflector
