Natcomm
Page 23
PROGRAMMING PROCEDURE
1.
TURN OFF POWER TO YOUR UNIT
2.
SWITCH ON POWER AND PRESS #
(use a Telephone connected to
DS3
)
3.
YOUR UNIT WILL OUTPUT 3 SHORT ‘BEEPS’
(you are in
Program Mode)
If you do not hear 3 beeps, return to the start (1).
4.
ENTER ANY PROGRAMMING COMMANDS AS FOLLOWS:
(Note - You can change one or more parameters in any order)
A.
NUMBER OF RINGS
To enter the NUMBER OF RINGS press #1xx where xx = number
of rings and can be 01-99 (for example, press #115 for 15 rings)
B.
DOOR PHONE CALL ADVICE TONES
To disable TONES press #40
To enable TONES press #41
C.
MAXIMUM DOOR PHONE CALL TIME
To enter the MAX CALL TIME press #3xx
xx = time limit in seconds and can be 15-99
(for example, press #360 for 60 seconds)
Note : If you enter * before the 15-99, it will increase the maximum Dial Out call time by 10.
Ie; entering #3*50 will set a maximum dial out time of 500 seconds, instead of 50 seconds.
D.
DIAL OUT FACILITY
To enter the DIAL OUT TELEPHONE NUMBER
press **x**
where x = the complete phone number.
ie : if the Dial Out Telephone Number is 0401234567 you should
press
**0401234567**
Note - You then need to ENABLE the Dial Out facility to dial out
after the ring count or immediate. See page 7.
