Nasum A5, Руководство пользователя

Страница: 13 / 28

13
C. Engraving speed, engraving energy and engraving size Setting
a. recommending the engraving speed for 1000, this is the best value
for the engraving effect after repeated experiments, of course you can
increase or decrease the speed according to your preference, faster speed
will save the engraving time, but it may reduce the engraving effect,
slower speed is the opposite.
b. In the selection of the laser mode, there are two commands for laser,
M3 and M4, it is recommended to use the M4 command for 1bit litter
engraving, and M3 command for other cases. If your laser only has M3
instruction, please check whether the laser mode is enabled in the GRBL
configuration, please refer to the official instructions of LaserGRBL for
GRBL configuration.
c. Choose the engraving energy according to different materials, we
have attached the engraving and cutting parameters of common materials
at the end of the manual for your reference.
Picture 3.9
6.$&*5%#$"*.(*+(7'$%2(6.$'&+-#' (