NARVI STEAM READY, Инструкция по установке и эксплуатации

Страница: 17 / 64

7. OVERHEAT PROTECTION
- Once the temperature of the stone housing exceeds
320 degrees, a separate overheat protection circuit
cuts the power feed to the heating elements.
As a result, the following text will be displayed on
the screen: Er3
- The overheat protection circuit is in the connection
casing of the heater
- The overheat protection circuit can be mechanically
reset by pressing the return button
- Once the heater has cooled down to under 280
degrees, the overheat protection can be restored
- Overheat protection can only be reset by a person
who is certified to do electrical work.
- Turn the mains switch to the 0 position
- The return button is pressed with enough force to
hear a click (see image 3)
- Turn the mains switch to the power-on position
8. PLACEMENT OF SAUNA HEATER STONES
- The electric sauna heater stones must be specific heavy and large 10-15 cm
diameter cut-off stones intended for heat-retentive sauna heaters
- The use of ceramic, lightweight, or stones with few edges or of even sizes are not
allowed. These may cause poor air circulation in the stone housing.
Soft soapstones cannot be used as heater stones
- The stones should be rinsed with water prior to being placed in the heater
- When positioning the stones, care must be exercised to prevent the heating elements
from bending or limiting air circulation
- Position the stones scarcely. If the stone housing is loaded too full, sufficient air
circulation will be prevented
- The stone housing must be completely filled, while ensuring that the cover can
properly close
- The heater stones should be inspected and repositioned annually and the stones
should be replaced every 2-3 years
- The heater cannot be heated without the stones in place
- Initial heating of the stove must be completed twice (heat for one hour using full power).
9. HEATING THE SAUNA ROOM FOR USE
- The heater stones are ready to use for bathing due to the initial heating, but raising
the temperature of the sauna room to a pleasant temperature will require some
additional time
- The heater is set to full power, the cover is opened and 5-15 minutes later the sauna
has reached a pleasant temperature
- Water can be thrown on the heater stones to increase the temperature in the sauna
prior to bathing
Image 3
Return button
Overheat protection