NARVI Softy 9kW, Инструкция по установке и эксплуатации

Страница: 14 / 64

3. INSTALLATION:
3.1 Instructions for the installation of the electric stove and sensor
– The stove may be connected to the power network only by a competent electrician
according to established regulations.
– Rubber cable H07RN-F or corresponding cable must be used as the connection
cable. The diameter of the cable and fuse sizes are shown in table 1.
- Connection of the power cable
- Place the stove on the floor, with the
front side down.
– Remove the bottom plate.
– Connect the connection cable.
– Attach the bottom of the box.
– Turn the stove upright.
- Install the sensor in the location indicated
in figure 2.
– Attach the sensor with the screws provided
in the set (2 pcs, ∅ 2.9 x 16).
– The wiring for the sensor may be countersunk.
Figure 1. Minimal safety clearances for the SOFTY stove.
The installation of a
stove in a wall recess
Figure 2.1. Connection of circuit board
Sensor outlet
Control console
outlet
C min
B min A min
min 3 cm
A min
A min
max 30 cm
A min
min. 60cm
M
ax. 90cm
HUOM! Ohjausyksikköä ei saa
asentaa seinäsyvennykseen.
Kuva 5.
10cm
Kuva 4
5cm
5cm
Figure 2.
3.2 Installing the Softy stove and piling the stones
– The stove is intended for installation on the floor.
– When installing the stove, make sure to consider the safety clearances.
– The body of the Softy 4.5 kW stove is permanently installed and in one piece.
– The stove is attached to the wall or sauna benches with two fastening elements
as shown in figures 4.1 and 4.2.
– The bodies of the Softy 6.0 and 9.0 kW stoves have two pieces.
– The stove is attached to the wall or sauna benches with two fastening elements
as shown in figures 3 and 4.
Kuva 3
66
Kuva 2
Kuva 3.1
66
Kuva 6
Kuva 3.2 Kuva 3.3 Kuva 3.4
Kuva 3
66
Kuva 2
Kuva 3.1
66
Kuva 6
Kuva 3.2 Kuva 3.3 Kuva 3.4
Figure 3. Figure 4. Figure 4.1.
Kuva 3
66
Kuva 2
Kuva 3.1
66
Kuva 6
Kuva 3.2 Kuva 3.3 Kuva 3.4
Kuva 3
66
Kuva 2
Kuva 3.1
66
Kuva 6
Kuva 3.2 Kuva 3.3 Kuva 3.4
Figure 4.2.