Stage 4:
ELECTRICAL CONNECTION
- The connection of the sauna stove to the electrical network can only be carried out
by a qualified electrician in accordance with the valid regulations.
- A rubber cable of type H07RN-F or similar must be used as a connection cable.
The cross-sectional surface of the cable and the size of the fuse can be seen in Table 1.
- The cross-sectional surfaces of the wires which are connected from the sauna stove to
the heating and signal lights must correspond to the feed cable of the sauna stove.
- First connect the connection cable to the terminal strip in the connection box of the
sauna stove.
- Turn the stone room+electrical box upside down.
- Open the bottom of the electrical box.
- Connect the connection cable.
- Fasten the bottom of the box.
- Turn the stone room+electrical box right side up.
Stage 5:
INSTALLATION ON THE WALL
Stage 6:
TO PILE THE STONES
- The stones are piled on the top of the fire grate
in the stone capacity, in between the heating
elements (resistors) so that the stones support
each other. Please make sure that the resistors
are not supporting the weight of the stones.
- When piling the stones, make sure that the resistors
are not bending and there is sufficient air circulation.
- Do not pile the stones densely. A stone basket
which has been filled too densely causes
overheating of the resistors (= a shorter lifetime)
and slows down warming up the sauna.
- The stone size diameter suitable for the sauna
stove is 4-7 cm.
- The stones must completely cover the heating
resistors (Figure 7).
E min
A min
min 20 cm
C min
A min
B min
Figure 7.
A
B
C
Figure 6.
- Draw in the lugs on the rear side of the
sauna stove through the mounting slots
of the mounting plate on the wall (Fig.6A).
- Push the upper edge of the mounting
plate between the jacket and upper
frame of the sauna stove and make
sure that the lugs of the stove are
wedged into the slots of the mounting
plate on the wall (Figure 6B).
- Tighten the upper edge of the sauna
stove with a locking screw (Figure 6C).
- The stone basket is now locked in the
jacket and on the mounting plate of
the sauna stove.
A STONE BASKET WHICH HAS NOT BEEN FILLED COMPLETELY CAUSES A FIRE RISK!
Use of ceramic stones that are light, porous and of the same size is prohibited, as they can
cause the resistors to heat up too much and break. Similarly, soft soap stones cannot be
used as sauna heater stones.
Содержание NM 450
