3
[PREPARATION]
(i)
Attach the angle adjusting plate to the body by the fixing screws.
Fit the bottom and secure the plate firmly to avoid misalignment.
(ii)
Insert the two gates at the gate positions shown in
the illustration in [SPECIFICATIONS] above. Be
careful not to bend the gates.
(iii)
Insert the footing of BeeSpi V into the rail as shown on the picture below. If you purchased the
OS-KB. Apply the BeeSpi V to the rail and push it firmly until it is securely attached.
(iv)
The sliding body for collision experiments is to be put on the rail on the body, between the gates.
It is a grooved plastic body sliding on the rail that has two grooves that fit the rails. Place it so
that these grooves are right on the rails.
