NARGESA NOA60, Инструкция

Страница: 15 / 116

- 16 -
EMBOSSING MACHINE NOA60
5.4.1. Changing the rollers
To change the rollers, raise the upper shaft using the Adjustment Wheel. Remove bolts 1 and 2 to release
components 3 and 4, take out the lower guide 5. If you wish to emboss handrails, fit smooth roller 7 onto
the lower shaft and the roller with the desired design 8 onto the upper shaft, fit the lower guide 5 into its
housing, fit components 3 and 4 together with bolts 1 and 2 to secure them. Then fit the admission guide
11, which will be secured with bolt 12 to the machine. The NOA60 is now ready to begin adjustment, which
will be explained in the following chapter.
If you wish to mark a tube, change roller 7 and 8 for rollers 9
DO NOT INSTALL the lower guide 5, as it is
not necessary to mark tubes, fit components 3 and 4 with bolts 1 and 2 as well as the corresponding
admission guide 11.