NARGESA NOA60, Инструкция

Страница: 14 / 116

- 15 -
5.3. Operation modes
The Nargesa NOA60 embossing machine has 2 different operation modes, which are:
Manual: Mode in which we can adjust the machine for production.
Continuous/Automatic: For working in continuous mode.
5.3.1. Manual operation mode
This mode of operation allows total control of the Nargesa NOA60 embossing machine at a reduced and
fixed rotation speed, to adjust the machine.
To select Manual Operation, start up the machine as indicated in section 5.2 and rotate the selector to
manual operation mode, from that moment and with the aid of the pedals, you can control the direction
of rotation of the machine forwards or backwards, depending on the pedal pressed, when you stop
pressing the pedal, the machine will stop. In this mode of operation, it is possible to adjust the machine.
5.3.2. Continuous/Automatic operation mode
Once the Nargesa NOA60 embossing machine is adjusted, this mode is used to begin mass production.
To select this mode, turn the selector to the
Continuous/Automatic position to start the machine:
- Press the Start Continuous/Automatic button on the control panel and the machine will begin to operate
non-stop. To stop you will have to press the Stop Button.
In this mode of operation, the potentiometer on the Control Panel will enable you to adjust the speed of the
machine.
5.4. Changing Rollers and Adjusting
The Nargesa NOA60 embossing machine, as commented above, embosses designs from the rollers onto
the material. This chapter will explain how to change the rollers and how to adjust them for optimum
results.
Take into account the the marking of the different materials needs different rollers, i.e., if you are marking a
tubular section you will need two identical rollers to make the same markings on the faces, if it is a handrail,
you will need a smooth roller for the lower face and an embossed one for the upper. In both types it will be
necessary to have entry guides for the material adequate for each dimension.