DRYER 400
4 |
P a g i n a
DENTAL
Nardi Compressori – www.nardicompressori.com
1.04
COMPONENTS:
The DRYER is composed of:
1.
Cooling coil inlet air
2.
First stage of moisture separation
3.
Tank with absorbent cartridge
4.
Non-return valve dry air
5.
Storage tank for regeneration of the desiccant material
6.
Automatic condensate drain solenoid valve
1.05 TECHNICAL DETAILS DRYER 400 :
Description
Unit
DRYER 400
Regeneration
Process without heat
Application
Air
Nominal capacity
L/min
400
Working pressure
Bar
8 (Max 10)
Regen. air. consum.
0
Max temp. air in
°C
45
Working temp.
°C
-5 +45
Fitting in/out
3/8'' - 3/8''
Power supply
Volt / Hz
220/50 - 60 or 110/50
Power cons.
Watt
17
Silicalgel charge
Kg
1,15
Electrical protection
IP55
Total weight
Kg
7
2
SAFETY REGULATIONS
2.01 SAFETY REGULATIONS FOR THE OPERATOR AND FOR THE PROPER USE OF DRYER 400:
The operator of DRYER 400 must have technical knowledge on the relevant safety regulations and be
familiar with the operation of the machine perfectly. In the case of delegation of work, the operator must
inform the next operator of all of the operations required for the proper use of the machine.
The compressor draws air from the surrounding environment (the operator must make sure it is devoid of fumes and / or
harmful gases) and passing through a suction filter begins the cycle of compression/filtering up to the tank. Moreover, it
is necessary to install an 8-bar safety valve with a flow rate of not less than 400 l/min on the system under pressure after
the DRYER.
