Napoleon TravelQ 285X, Руководство пользователя

Страница: 12 / 40

12
EN
www.napoleon.com N415-0536 NOV 2. 20
Troubleshooting
Problem Possible Causes Solution
Low heat / Low flame when valve
turned to high.
Blockage of gas.
Improper preheating.
Cylinder freezing up.
Check for spider webs in the burner or orifice.
Preheat grill with main burners on high for 5 to 10 minutes.
When cooking for long periods of time, or when the cylinder
is close to being empty, or low outside air temperatures, 1 lb
cylinders do not have enough wetted surface area to allow
liquid propane to turn to vapor. Put on a fresh 1 lb cylinder
or hook-up to a 20 lb tank.
Excessive flare-ups/uneven heat. Improper preheating.
Excessive grease and ash build up in
drip pan.
Preheat grill with both main burners on high for 5 to 10
minutes.
Clean drip pan regularly. Do not line pan with aluminum foil.
Refer to cleaning instructions.
Burners burn with yellow flame,
accompanied by the smell of gas.
Possible spider web or other debris,
or improper air shutter adjustment.
Thoroughly clean burner by removing. See general
maintenance instructions. Open air shutter slightly
according to combustion air adjustment instructions. (This
must be done by a qualified gas installer.)
Flames lift away from burner,
accompanied by the smell of gas,
and possibly difficulties in lighting.
Improper air shutter adjustment. Close air shutter slightly according to combustion air
adjustment instructions. (This must be done by a qualified
gas installer.)
Burner will not light with the igniter
but will light with a match.
Jet-fire outlet is dirty or clogged. Clean jet-fire outlet with a soft bristle brush.
Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal vibrations in the
regulator and does not affect the performance or safety of
the gas grill. Humming regulators will not be replaced.
“Paint” appears to be peeling inside
lid or hood.
Grease build-up on inside surfaces. This is not a defect. The peeling is caused by hardened
grease, which dries into paint-like shards that flake off.
Regular cleaning will prevent this. See cleaning instructions.
Burner output on “high” setting
is too low. (Rumbling noise and
fluttering blue flame at burner
surface.)
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Spider webs or other matter in
venturi tube.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.