Napoleon PRO665, Руководство пользователя

Страница: 17 / 64

17
www.napoleongrills.com
EN
Problem Possible Causes Solution
Infrared burner (if equipped)
flashes back (during
operation the burner
abruptly makes a loud
“whoosh” sound, followed
by a continuous blow-torch
type sound and grows dim.)
Ceramic tiles overloaded with
grease drippings and build-up.
Ports are clogged.
Burner overheated due to
inadequate ventilation (too much
grill surface covered by griddle or
pan.)
Cracked ceramic tile.
Leaking gasket surrounding the
ceramic tile, or a weld failure in the
burner housing.
Turn burner off and allow to cool for at least
two minutes. Relight burner and burn on high
for at least five minutes or until the ceramic
tiles are evenly glowing red.
Ensure that no more than 75% of the grill
surface is covered by objects or accessories.
Turn burner off and allow to cool for at least
two minutes, then relight.
Allow burner to cool and inspect very closely
for cracks. If any cracks are found, contact
your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for
instructions on ordering a replacement burner
assembly.
Electronic Ignition not
working.
Unit not connected to power.
Blown Fuse.
Faulty transformer.
Terminals on switch or circuit
board are corroded or loose.
Faulty igniter.
Dirty or corroded electrodes.
Plug power cord into a working GFI protected
outlet.
Replace fuse located on outlet line of
transformer.
Check transformer output – should be 12VAC.
Replace if required.
Clean connections and ensure connectors
are pushed together firmly. Access to circuit
board is under electrical cover on left side of
cabinet.
Replace igniter – located under electrical
cover.
Clean or replace as required.
Oven and control panel lights
not working
Unit not connected to power.
Blown fuse.
Faulty transformer.
Terminals on switch or circuit
board are corroded or loose.
Bulbs blown (oven lights only).
Plug power cord into a working GFI protected
outlet.
Replace fuse located on outlet line of
transformer.
Check transformer output – should be 12VAC.
Replace if required.
Clean connections and ensure connectors
are pushed together firmly. Access to circuit
board is under electrical cover on left side of
cabinet.
Replace bulbs as per the instructions in the
maintenance section of the manual.