Napoleon PRO285, Руководство пользователя

Страница: 12 / 28

12
EN
www.napoleon.com N415-0437-AU MAY 10.22 REV -
WARNING!
Hose (optional): Check for abrasions, melting, cuts, and cracks in the hose. If any
of these conditions exist, do not use the gas grill. Have the part replaced by your Napoleon Gas Grill
dealer or qualified gas installer.
!
WARNING!
When reinstalling the burner after
cleaning it is very important that the valve/orifice
enters the burner tube before lighting your gas grill.
If the valve is not inside the burner tube a fire or
explosion could occur.
!
Burner : The burner is made from heavy wall 304 stainless steel, but extreme heat and a corrosive
environment can cause surface corrosion to occur. This can be removed with a brass wire brush.
CAUTION!
Beware of Spiders.
Spiders and insects are attracted to the smell of propane and natural gas. The burner is equipped with
an insect screen on the air shutter, which reduces the likelihood of insects building nests inside the
burner but does not entirely eliminate the problem. A nest or web can cause the burner to burn with a
soft yellow or orange flame or cause a fire (flashback) at the air shutter underneath the control panel. To
clean the inside of the burner, it must be removed from the gas grill: Remove the screw (s) that attach the
cross light bracket and the burner to the base. Slide the burner back and upwards to remove. Cleaning:
Use a flexible venturi tube brush to clean the inside of the burner. Shake any loose debris from the burner
through the gas inlet. Check the burner ports and valve orifices for blockages. Burner ports can close over
time due to cooking debris and corrosion; use an opened paperclip to clean them. The ports are easier to
clean if the burner is removed from the grill, but it can also be done with the burner installed.
CAUTION!
Take care not to enlarge the holes.
Ensure the insect screen is clean, tight, and free of any lint or other debris.
Reinstallation
: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace cross light bracket and tighten screws to complete reinstallation.