Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • 1(866)820-8686 • www.napoleon.com
Minimum Clearance to Combustibles
•
When using paint or lacquer to fi nish a mantel, the paint or lacquer must be heat resistant to prevent discoloration.
!
WARNING
W415-2023 / 07.04.19
NEFL60B-1
REAR VIEW
12"
(305mm)
6"
(152mm)
2"
(51mm)
6"
(152mm)
Measurements are taken from the glass front.
Bottom
2” (51mm)
Sides
6” (152mm)
Back
0”
Top
39 3/8” (1000mm) to ceiling / mantel
The power switch is located on the top left hand side of the appliance. Ensure that this power switch is always
accessible.
note:
39 3/8”
(1000mm)
Wall Mount Installation
Due to the many different materials used on different walls, it is highly rec-
ommended that you consult your local builder before you
install this appliance on the wall.
A.
Select a location that is not prone to moisture and is located
at least 3 feet (1m) away from combustible materials such as
curtain, drapes, furniture, bedding, paper, etc.
B.
Remove the wall mounting bracket from the appliance by
unscrewing the 2 screws holding the wall mounting bracket to the
appliance
(Fig. 1)
.
C.
Have two people hold the appliance against the wall to determine
the fi nal location.
D.
Mark out location, then mount the bracket onto the wall using
screws (supplied)
(Fig. 2)
. This bracket MUST have the hooks
facing upward and be level.
E.
With the wall mounting bracket installed, have two people lift the
appliance up and align the slots on the back of the appliance with
the hooks on the wall bracket.
F.
Secure the appliance to the wall bracket using the 2 screws
previously removed in Step B.
It is strongly recommended that the mounting bracket be
screwed into the wall studs where possible. If the wall studs
cannot be used, ensure that the supplied plastic anchors
are used to affi x the bracket to the wall and the bracket is
adequately secured.
The wall bracket is fi xed on the back of the appliance.
note:
note:
REAR VIEW
SLOTS
X2
Fig. 2
Fig. 1
Screws
Mounting Bracket
