Napoleon IR3N-1, Инструкция по установке и эксплуатации

Страница: 19 / 80

19
W415-1342 / 10.01.14
EN
A. Using the remote transmitter you may set the fl ame directly to the "HI" setting by double clicking the
large fl ame button . Increasing the fl ame height can also be done by pressing and holding the large
fl ame button .
B. Using the remote transmitter you may set the fl ame directly to the "LO" setting by double clicking the
small fl ame button . Decrease the fl ame height can also be done by pressing and holding the small
fl ame button .
NOTE: For fine adjustment tap the large flame button or small flame button when using the remote
transmitter. If the small flame button is held too long the main burner will turn off.
NOTE: Time display will flash upon battery installation or when the large and small flame buttons are
pressed simultaneously.
A. To set the hour press the large fl ame button .
B. To set the minutes press the small fl ame button .
C. Press the "OFF" button to set the time.
A. To set the Timer Mode quickly press the SET button, scrolling to the desired mode.
B. To scroll through P1 , P1 , P2 , P2 briefl y press the set button.
C. Once the desired timer function is shown on the display and the time fl ashes, press the large fl ame
button to adjust the hour and the small fl ame button to adjust the minutes. Press the "OFF" button
to set the time.
NOTE: The default setting for the Timer Function is as follows: P1 6:00am and P2 8:00pm, P2
11:50am and P2 11:50pm, refer to "GENERAL REMOTE TRANSMITTER LAYOUT".
6.2.8 SETTING THE TIME
6.2.9 SETTING THE TIMER FUNCTION
6.2.10 FLAME HEIGHT
C. To set Nighttime Temperature Mode quickly press the SET button, scrolling to the desired mode, then
hold the SET button untill the "TEMP" on the display fl ashes.
D. To increase the Nighttime Temperature press the large fl ame button . To decrease the Nighttime
Temperature press the small fl ame button . To use this setting as the new temperature press the OFF
button.
NOTE: When in regular operation the remote will always show the room temperature. Thermostat
function adjusts the flame height according to the difference between the set temperature and the
actual room temperature; as the room temperature gets closer to the set point it will adjust the flame
down.
A. Frequent beeping for 3 seconds when the appliance turns on indicates low battery on the remote
receiver. The battery pack is located on the bottom right side of the appliance, refer to "INSTALLATION
OVERVIEW" for location.
B. Low battery indicator is in the top right corner of the remote, we also recommend replacing the
batteries every two years.
NOTE: When low battery occurs the appliance will shut down. The appliance will shut off if no change
has occurred to the flame height or the appliance has not turned on for a period of 5 days.
6.2.7 LOW BATTERY