W415-2164 / A / 07.21.16
14
EN
5.4 LOGO PLACEMENT
½"
½"
½"
½"
Remove the backing of the logo supplied. Centre the
logo on the front of the appliance, ½” in from the left
side, as shown.
6.0 OPTIONAL REMOTE INSTALLATION
RECEIVER
BATTERY
PACK
SLIDE
SWITCH
FACEPLATE
PRE
SS
TO OPE
N
FIREPL
ACE
REM
OT
E
OFF
ON
REM
OTE
BA
T.L
OW
VALVE
REAR BURNER BASE
A.
Remove the battery pack from the receiver. Then by pulling down, remove the receiver cover and
slide the receiver into the hole located at the rear of the burner base. Secure using the two screws
provided.
B.
Secure the faceplate to the receiver with two of the screws provided.
C.
Insert the battery pack (with batteries installed) through the opening in the faceplate and into the
receiver. The battery pack is secured and released with a catch mechanism. Push the receiver into
the catch to secure.
D.
Insert the slide switch into its marked position on the faceplate.
E.
Replace the existing switch wires connected to the terminals on the valve marked TH/TP and TH
with those running from the receiver.
NOTE: The remote switch on the side of the unit is no longer operational.
