Low battery alarm
Key Lock
Room
Temperature
LED Light
Flame ON
Blower
Transmission
CPI mode
GENERAL TRANSMITTER LAYOUT
INITIALIZING THE TRANSMITTER FOR THE FIRST TIME
A.
Power the receiver.
B.
Press the reset button to begin the programming process.
C.
The receiver will BEEP 3 times to indicate that it is ready to synchronize with a transmitter.
D.
Install the 3 AAA batteries into the transmitter battery bay, located on the base of the transmitter,
then press the “ON” button. The receiver will BEEP 4 times to indicate the transmitter’s command
is accepted and sets to the particular code of that transmitter. The system is now initialized.
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING
THE RESET/PROGRAMMING BUTTON.
TRANSMITTER
(HAND HELD REMOTE)
A.
With the system in the “OFF” position, press the
Temperature Key and the Mode Key at the same
time to change from degrees F to C.
B.
Look at the LCD screen on the Transmitter to
verify that a C or F is visible to the right of the
Room Temperature display.
35.5A
73
°F
23
°C
TEMPERATURE DISPLAY
FLAME HEIGHT
The remote control has six (6) fl ame levels. With the
system on and the fl ame level at the maximum, press
the Down Arrow Key once and it will reduce the fl ame
height by one step until the fl ame is turned off.
The Up Arrow Key will increase the fl ame height each
time it is pressed. If the Up Arrow Key is pressed while
the system is on but the fl ame is off, the fl ame will
come on the high position. A single “beep” will confi rm
reception of the command.
76
°F
OFF
76
°F
76
°F
76
°F
Hi
FLAME OFF
FLAME AT LEVEL 1
FLAME AT LEVEL 5
FLAME AT “HI” LEVEL 6
35.8A
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • (705)721-1212 • fax (705)720-9081 • www.napoleonfireplaces.com
W415-1682 / B / 01.11.17
