W415-1767 / B / 11.23.17
EN
12
installation
2.6 installing the appliance
A.
Frame the appliance along with the electrical connections.
B.
Remove the front trims on both front side and back side. Refer to “front trim installation / removal” section.
C.
Remove the front glasses on both front side and back side. Refer to “front glass installation / removal”
section.
D.
To determine the installation location of the mounting bracket, ensure to line up the edge of the mounting
bracket 1/4” (6.4mm) from the center of the stud and 6 1/8” (156mm) from the bottom of the stud (FIG. 1 &
2).
E.
Mark the holes for the mounting bracket (FIG. 3).
6 1/8”
(156mm)
1/4”
(6.4mm)
Center of the stud
F.
Drill marked holes.
G.
Secure the mounting brackets onto the drilled holes with supplied fasteners (#1 x 4).
H.
Insert the appliance to the frame and secure the appliance to the holes on the bracket using supplied
fasteners (#2 x 4) using the slots from the appliance (FIG. 4).
I.
Install media. Refer to “media installation” section.
J.
Reinstall front trim and glass. Refer to “front trim installation / removal” and “front glass installation /
removal” sections.
EN
EN
EN
6 1/8” (156mm)
FIG. 1
FIG. 3
FIG. 4
FIG. 2
It is recommended to have the walls of the appliance enclosure be finished (i.e. drywall) to avoid exposed
insulation or vapour barrier coming in contact with the appliance. This will ensure clearance to combustibles is
maintained.
note:
Wall anchors are not required when screwing into the wall stud.
#2 x 4
#1 x 4
The mounting bracket must be screwed into the wall studs with at least 2 screws. If the remaining screws
cannot be screwed into a stud, ensure that plastic anchors (provided) are used to affix the bracket to the wall
and that the bracket is adequately secured.
