Napoleon BIPRO 825, Инструкция по эксплуатации

Страница: 4 / 72

4
www.napoleongrills.com
EN
Gas Cylinder
Use only gas cylinders, which meet national and regional codes. The minimum cylinder size for butane
units is 13kg, and for propane units is 6kg. Ensure that the cylinder can provide enough fuel to operate the
appliance. If in doubt, check with your local gas supplier.
• Use caution when handling the cylinder valve.
•
Never connect a cylinder, which does not meet local codes.
• Only cylinders connected to the appliance may be stored in the enclosure, or close to the appliance.
Enclosures must comply with the BUILT IN CYLINDER ENCLOSURES paragraph in the following section.
Spare cylinders must not be stored in the enclosure, or in close proximity of an operating unit.
Cylinders must not be exposed to extreme heat or direct sunlight.
Cylinder Connection : Remove the cap or plug from the cylinder fuel valve. Tighten regulator to cylinder
valve. Leak test all joints prior to using the barbecue. A leak test must be performed annually, and each
time a cylinder is hooked up, or if a part of the gas system is replaced.
Gas Hose
WARNING!
This gas grill must be installed by a licensed gas fitter. The gas grill can not be
connected to the gas supply using hoses except to connect the cylinder regulator to the piping system.
The increased temperature within the enclosure may cause the hose to melt. Use the provided flexible
metal connector to connect the gas grill to either approved rigid piping, approved copper tubing or
approved flexible metal connectors. Ensure the installation conforms to all local and national codes.
The entire gas supply installation must be leak tested before operating the gas grill. Refer to the manual
for complete grill assembly instructions.
• If the hose and regulator are not included by the manufacturer, then only hoses and regulators which
meet national and regional codes are to be used.
• Ensure that the hose does not come into contact with grease, other hot drippings, or any hot surfaces
on the appliance.
• Check hose regularly. In the case of rips, melting or wear, replace hose before using the appliance.
• The recommended hose length is 0.9m. The hose must not be longer than 1.5m.
• Ensure that the hose is twist and kink free when installed.
•
Replace the hose before expiry date printed on the hose.
Example Cylinder
Correct Disposal Of This Product
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.