Napoleon BEF33H, Руководство по обслуживанию

Страница: 11 / 34

W415-1696 / 10.12.16
11
EN
!
WARNING
4.0 TROUBLESHOOTING
Ember bed is not
glowing or dimming One log has no light/the ember
bed light is uneven
No light from the ember bed and
logs
1. If the LED strip has one or more LEDs that does not light up, refer
to section 4.2
1. Press the fl ame button on the control panel to cycle through
the brightness levels as this could restart the ember bed LED
strip.
2. If the LED light is still off, refer to section 4.2
No warm air is coming
out of the appliance
LED indicator light is
fl ashing
LED fl ashes 8-10
seconds after pushing
heater button
Heater shuts off and
LED fl ashes after 30
seconds
Heater is on but little
to no heat is produced
Room temperature is higher than
the set temperature setting
Appliance has overheated
High limit switch is open / has
malfunction
Blower malfunction
One or more heating elements
has malfunctioned
1. Set temperature to a higher setting with remote control.
2. If heater does not turn on, proceed with "LED indicator light is
fl ashing" test solution.
1. Unplug the appliance and wait 15-20 minutes for the appliance
to cool down
2. Ensure nothing is blocking the air fl ow from the exhaust of the
appliance
3. Plug in the appliance. If problem persists, refer to section 4.3
1. Refer to section 4.3
SYMPTOM PROBLEM TEST SOLUTION
Dim or no fl ame Dim Flame
No moving fl ame (LED light on)
No LED light
1. Press the fl ame button on the control panel to cycle through
brightness levels in order check if the light will get brighter.
2. If light is still dim, refer to section 4.1
1. Press the fl ame button on the control panel to cycle through
the fl ame settings (from F1, F2, F3, to F0) as this could restart the
rotisserie to animate the fl ame.
2. If fl ame is still not moving, refer to section 4.1
1. Press the fl ame button on the control panel to cycle through
the brightness levels
2. If the LED light is still off, refer to section 4.1
IF YOU ARE EXPERIENCING ANY OF THESE ISSUES, UNPLUG APPLIANCE FROM THE POWER OR TURN OFF
CIRCUIT BREAKER FOR 30 SECONDS TO FACTORY RESET THE APPLIANCE.
TURN OFF THE APPLIANCE COMPLETELY AND LET THE APPLIANCE COOL DOWN BEFORE SERVICING.
FOR ALL HARDWIRED APPLIANCES, DO A VOLTAGE TEST TO ENSURE THAT THERE IS NO POWER RUNNING
THROUGH THE UNIT.
Thermostat failure
One or more colours are
not visible
No LED light
1. Ensure wire connections are fi rmly connected at the thermostat
and PCB.
2. If appliance is still showing error code E1, replace thermostat.
Refer to section 5.8
1. Press the decorative light button on the remote control
to set the unit to the d2 setting. Wait for 60 seconds.
2. If any of the colours are not working, refer to section 4.4
1. Ensure wire connections are fi rmly connected at the thermostat and
PCB.
2. If unit is still showing error code E2, replace thermostat.
Refer to section 5.8
3. If unit is still showing error code E2, replace the PCB.
Refer to section 5.6
E1 Error Code
Decorative LEDs
are not functioning
properply
E2 Error Code Thermostat or PCB is shorting