Napoleon Auburn NPS40, Инструкция по установке и эксплуатации

Страница: 28 / 48

W415-0616 / E / 10.08.08
28
(Insert
Illustrated)
The main viewing door has been boxed separate from the heater, but must be installed
before burning the heater.
7.3.1 Open both side panels, exposing the bushing on the left and the
latches on the right.
7.3.2 Align the pins on the door to the bushing on the left side of the heater.
lower into place until both bushings touch.
7.3.3 Engage the latch hooks into the door frame. Snap the rear handle
hook to lock the latch closed.
7.3 INSTALLING vIEWING dOOR
8.0 OPERATING INSTRUCTIONS
8.2 LIGhTING hEATER mANUALLY
Your heater can be lit manually without using the automatic igniter by following the procedure below.
● Press the ON / OFF button.
● Place a "handful" of pellets into the burn pot.
● Cover with a small amount of approved (non-volatile) fire starter gel.
● Light fire starter with a match and close the viewing door.
Heater may be hot.
Other than placing a handful of pellets in the burn pot for lighting manually, never feed pellets
through the glass viewing door. An "OVERFIRE" condition could occur, if more pellets enter the
firebox then what the feed tube can deliver. Pellets must only be burned within the burn pot.
!
WARNING
8.1 PROPER PELLET LOAdING
TP - PROPER PEllET lOAdING
TP - lIGhTING hEATER mANUAllY
Before loading pellets into the hopper first transfer the pellets from it's original plastic bag to a metal bucket.
Keep in mind that the auger stops when the lid is opened. If the lid is opened for several minutes, the fire may
extinguish.
NOTE: If the pellets are kept in the plastic bag, the bag may come in contact with the heater causing
the bag to melt and the pellets to spill.
DO NOT load pellets into the hopper if they have been exposed to moisture. Moisture can cause pellets
to swell and cause blockage in the feed system. Thoroughly dry pellets before placing into hopper.
fIGure 7.3
8.2.1
8.2.2
8.2.3
8.2.4