EN
W415-1707 / B / 06.04.18
27
rough framing - before appliance installation
single-sided
see-thru
Before framing your appliance, determine vent requirements before deciding the final location of the appliance.
After rough framing, place the appliance in its final position.
Before framing the appliance, ensure to install the
firestop first as it will not fit between the studs if
installed after framing.
* Minimum enclosure
height maybe higher de-
pending on venting con-
figuration (see minimum
distance to combustibles).
Ref
L38
L50
E
16 3/16” (41.1cm)
16 3/16” (41.1cm)
F
53 13/16” (136.7cm)
65 13/16” (167.2cm)
J
Optional - Appliance does not need to be elevated above floor
*L
73” (185.4cm)
73” (185.4cm)
Ref
L38
L50
E
17 15/16” (45.6cm)
17 15/16” (45.6cm)
F
53 13/16” (136.7cm)
65 13/16” (167.2cm)
J
Optional - Appliance does not need to be elevated above floor
*L
73” (185.4cm)
73” (185.4cm)
E
J
F
E
F
J
minimum framing
minimum framing
L
L
note:
The L series requires a minimum en-
closure height of 73” measured from
the bottom of the appliance. For tem-
perature requirements, this area must
be left unobstructed. Some venting
configurations that require more verti-
cal rise will require a larger enclosure
to provide minimum vertical clearance
between vent pipes and combus-
tibles. It is also recommended that the
enclosure be ventilated at the top and
bottom to circulate the hot air.
note:
The L series requires a minimum en-
closure height of 73” measured from
the bottom of the appliance. For tem-
perature requirements, this area must
be left unobstructed. Some venting
configurations that require more verti-
cal rise will require a larger enclosure
to provide minimum vertical clearance
between vent pipes and combus-
tibles. It is also recommended that the
enclosure be ventilated at the top and
bottom to circulate the hot air.
note:
note:
Before framing the appliance, ensure to install the
firestop first.
