Napoleon 1100PL, Инструкция по установке и эксплуатации

Страница: 28 / 36

28
W415-0762 / A / 07.19.10
8.6 GASKET REPLACEMENT
At the end of each burning season inspect the shield and gasket below the manifold for warping or
deterioration. Replace if necessary. Both are held to the manifold with machine screws. The shield and the 1/8”
fi bre cloth gasket are available from your Wolf Steel Ltd. dealer. At this time also check that the door gasket is
not worn or loose. Replace with 3/8” high density fi breglass rope if necessary.
The airwash gasket and shield above the door should also be inspected and replaced if deteriorated
NOTE: Do not operate appliance if the manifold shield or fi bre baffl e is deteriorated or missing.
8.5 GLASS REPLACEMENT
8.5.1 When the appliance is cool, open the
door and place the door frame down
careful not to scratch the paint.
8.5.2 Remove the screws and brackets
holding the glass in place. Remove all
broken glass.
8.5.3 Wrap the edges of the new glass with
a U-shaped strip of fi berglass gasket,
covering 1/4” on each side.
8.5.4 Place the glass with the fi berglass
gasket in position and replace the
brackets and screws. When fi nished,
you should be able to move the glass
slightly, horizontally and vertically.
NOTE: For replacement glass, size,
thickness and specifi cations see “REPLACEMENTS” section.
!
WARNING
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
APPLIANCE BEFORE OPERATION.
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
REMOVED, CRACKED, BROKEN OR SCRATCHED.
U-SHAPED
GLASS
GASKET
½” ROPE
DOOR
GASKET