CAUTION
•
Never smoke inside the tent. Never use candles, light
matches or allow any type of open flame in or near the
tent.
•
Do not cook inside the tent.
•
Do not store flammable liquids inside the tent.
•
Allow adequate ventilation inside the tent at all times.
Never refuel lanterns, heaters or stoves inside the tent.
Do not smoke inside the tent.
Leaving the tailgate open for an extended amount of
time will drain the battery of your vehicle.
NEVER run the engine when the tent is attached to the
vehicle.
•
•
•
- Select a smooth level campsite clear of rock, branches
and other hard or sharp objects.
- Park the vehicle into the chosen campsite with the vehicle
in park and turned off. Apply the parking brake.
Note:
The tent may be used as a standard ground tent by
simply unzipping the vehicle sleeve.
SETTING UP THE TENT
SELECT CAMPSITE
1)
Remove the tent from the tent bag and lay it flat on the
ground with the vehicle sleeve facing the cargo
area of the vehicle. The screen room must be on the
driver’s side. At this point, do not stake the tent to the
ground.
2)
Assemble the tent (6 steel & 5 fiberglass) poles by
unfolding each section.
5)
Once the tent is standing, attached the plastic clips to
the tent pole.
•
© 2011 Napier Enterprises – All Rights Reserved.
Rev. 00 11.10.10
2 of 10
3)
Slide a fiberglass pole diagonally, corner to corner going
through the pole sleeve in the roof of the tent. Place on
end into the center hub and the other end into the starred
end of the center joint. Repeat for the other 3 poles.
4)
Take a steel pole and insert on end into the joint and the
other end into the pin located on the bottom corner of
the tent. Repeat for the remaining pole.