CAUTION
•
Do not use candles, matches or open flames of any kind
in or near the tent.
Do not cook inside the tent.
Build campfires downwind and several metres away
from the tent and be sure to fully extinguish campfires
before leaving your campsite or before retiring for the night.
Allow adequate ventilation inside the tent at all times.
Do not refuel lamps, heaters or stoves inside a tent.
Extinguish or turn off all lanterns before going to sleep.
Do not smoke inside the tent.
Do not store flammable liquids inside a tent.
NEVER run the engine when the tent is attached to the
vehicle.
Do not install the tent when the temperature is below
0º/32ºF or when your vehicle is wet as it may cause
damage.
Do not attempt to drive the vehicle with the tent is attached.
•
- Select a level campsite.
- Park the vehicle into the chosen campsite with the vehicle
in park and turned off. Apply the parking brake.
SETTING UP THE TENT
SELECT CAMPSITE
1) Remove the tent from the tent bag and lay it flat on the
ground with the vehicle sleeve facing the cargo area of
the vehicle. At this point, do not stake the tent to the
ground.
2) Assemble the tent poles by unfolding each section.
3) Slide a fiberglass pole diagonally, corner to corner going
through the pole sleeve in the roof of the tent. Place one
end into the center hub and the other end into the starred
end of the center joint. Repeat for the other 3 poles.
5) Once the tent is standing, attach the plastic clips to
the tent pole.
•
© 2015 Napier Enterprises – All Rights Reserved.
Rev. 03 10.23.14
2 of 8
•
4) Take a steel pole and insert one end into the joint and the
other end into the pin located on the bottom corner of
the tent. Repeat for the remaining pole.
Exercise extreme caution when using fuel-powered
lanterns or heaters inside a tent and use battery-
operated lanterns whenever possible.
•
•
•
•
•
•
•
•
